The quick and easy solution for worn anti-roll bars and bushes.  

Eli-Flex is a revolutionary polymer resin that offers a durable lining between anti-roll bars and bushes. It is cheaper than a set of new bushes or anti-roll bars. The use of Eli-Flex enables PSV and HGV vehicle operators to save thousands of pounds by eliminating frequent new part replacement.

Existing users have found that their anti-roll bar bushes last 4-5 times longer after Eli-Flex has been applied. There is no need to fit new bushes with our resin kit, the old bushes can be re-used over and over again and also no need to replace costly roll bars, with Eli-Flex you can rebuild them to their original diameter and thickness.

The small Kit contains enough resin to repair 2 bushes, the large Kit contains enough resin to repair 4 bushes.

  • Eli-Flex is suitable for use on all makes and models of PSV and HGV (buses, minibuses, coaches & trucks)
  • Sachets have an indefinite shelf life in unopened foil packs
  • Twin packs enable quick, easy & clean mixing and application
  • Can be mixed and applied in 10 minutes without special tools
  • No need to remove the roll bar assembly, saving time
  • Cures in 2 hours at 20°C

Specifications

  Mix ratio    mixed and applied directly from pre-filled twin pack sachets 
  Heat resistance    85°C continuous exposure
  Curing time    2 hours at 20°C, 3 hours at 10°C
  Coverage   1mm thick application - 0.6m²/kg
  small kit is enough for 2 bushes
  large kit is enough for 4 bushes 
  Pot life    5-7 minutes at 25°C
  Chemical resistance    resistant to petrol, diesel and oil
  Tensile strength   4 MPa

 

Fitting Instructions

Remove the roll bar assembly, drop the bar and remove the bushes. Clean, degrease and roughen the worn area on the roll bar, then coat the inside of the bushes with a release agent.  

Open the sachet of Eli-Flex and slide out the separator clip from one side, mix by kneading and squashing the pack until it warms up - approximately 3 to 4 minutes. Cut open one corner of the pack with a knife or scissors  and squeeze the resin into the worn area. Spread the resin evenly around the bar with the spatula, fit the bush assembly and tighten.

Clean away any excess resin that extrudes from the sides, allow to cure for 2 hours at 20°C and return the vehicle to service.


Anti-Roll Bar brochure PDF

Anti-Roll Bar Technical Data Sheet PDF

Anti-Roll Bar Safety Data Sheet PDF

/industrial-products/anti-roll-bar-repair-resin

 

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

Anti-Roll Bar Repair Resin

  • Brand: Eli-Chem
  • Product Code: ARB Large & Small
  • Availability: 892
  • £42.12 Including VAT


Available Options


Tags: bushes, anti-roll bar, arb